Instuctions for Metal Lighters

Gas Refilling

(1)Be sure that no visible flame when filling with gas.

(2)Use the standard butane with the atmospheric pressure of 3.6-4.2.

(3)Invert the lighter, insert aerosol nozzle into lighter valve hole, and press it for 2 or 3 times.

Flame Adjustment

(1)Wait 1 minute or so after refilling and then adjust the flame.

(2)Use the suitable screw driver to turn the adjusting screw in the lighter base: higher flame, please turn left, "+" of the screw; lower flame, please turn right, "-" of the screw. Revolving angle should not exceed 60¡ãeach time, or it will result in unkindling.

(3)The best height of flame:about 3.0cm for flame lighter; about 2.0cm for windproof lighter; about 2.0cm for jet-flame lighter.

Flint Replacement

(1)Please replace the flint if there is noi spark when turning the grinding wheel towards the right direction.

(2)Pull out the midddle part, remove the screw, spring and the used flint in order, then use a new flint and put them back.

The Common Problems and Their Solutions for Metal Lighters

Order	Problems	Reasons	Solutions
1	No Flame	a.gas is use up b.gas leaks out c.get fire ater filing gas d.electricity leaks out from the piezoelectricity or no electricity, or the spring or no spark in the spring or the copper fitting e.other reasons	a.refill gas b.replace fittings c.wait about 1 minute before ignite the lighter (adjust the flame to a suitable height when necessary) d.replace the inner fittings e.other solutions
2	too high flame, with the sound of creak	too much gas coming out	adjust the screw in the lighter base,turn left,the "-" direction, untill the height is suitable
3	too low flame	too little gas coming out	adjust the screw in the lighter base,turn right,the "+" direction, untill the height is suitable
4	the flame shapes as round	/	replzce the inner fitings
5	the copper fiting becames loosend	/	replzce the inner fitings

Note: This is offered by Technology Denelopment Department of Honest Smoking Set.Co.,ltd.